If the rear bench seat/rear seat and seat backrest are not engaged they could fold forwards, e.g. when braking suddenly or in the event of an accident.
If this is the case, the vehicle occupant would be forced into the seat belt by the rear bench seat/rear seat or by the seat backrest. The seat belt cannot protect as intended and could result in additional injury.
Objects or loads in the boot/load compartment cannot be restrained by the seat backrest.
If the seat backrest is not engaged and locked, this will be shown on the multifunction display on the instrument cluster.
For ISOFIX or i‑Size child restraint systems in which the child is secured using the seat belt integrated in the child restraint system, the permissible gross mass of the child and child restraint system is 33 kg.
If the child and the child restraint system together weigh more than 33 kg, the ISOFIX or i‑Size child restraint system with integrated seat belt does not offer sufficient protection. Too much load may be placed on the ISOFIX or i‑Size child restraint systems and the child may not be restrained correctly in the event of an accident, for example.
in the manufacturer's installation and operating instructions for the child restraint system used
on a label on the child restraint system, if present
Regularly check that the permissible gross mass of the child and child restraint system is still complied with.
Always observe the correct use and the suitability of the seats for attaching a child restraint system. ISOFIX child seat securing system More i‑Size child seat securing system More- Always comply with the manufacturer's installation and operating instructions for the child restraint system used.
- Make sure that the child's feet do not touch the front seat. If necessary, move the front seat forward slightly.
When fitting an ISOFIX child restraint system, observe the following: - When using a Group 0/0+ baby car seat or a Group I rearward-facing child restraint system on a rear seat: adjust the front seat so that the seat does not touch the child restraint system.
- When using a Group I forward-facing child restraint system: remove the head restraint from the respective seat, if possible. In addition, the seat backrest of the child restraint system must, as far as possible, lie flat against the backrest of the vehicle seat. When you remove the child restraint system, install the head restraint again immediately and adjust all the head restraints correctly.
- For certain child restraint systems in weight group 2 or 3, there may be restrictions in the maximum size setting, e. g. due to possible contact with the roof.
- The child restraint system must not be put under strain between the roof and the seat cushion and/or be fitted facing the wrong direction. Where possible, adjust the seat cushion inclination accordingly.
- The child restraint system must not be put under strain by the head restraints. Adjust the head restraints accordingly.
When fitting an i‑Size child restraint system, observe the following: - When using a rearward-facing child restraint system: adjust the front seat so that it does not touch the child restraint system.
- When using a forward-facing child restraint system: remove the head restraint from the respective seat, if possible. In addition, the seat backrest of the child restraint system must, as far as possible, lie flat against the backrest of the vehicle seat. When you remove the child restraint system, install the head restraint again immediately and adjust all the head restraints correctly.
Before every trip, make sure that the ISOFIX child restraint system or the i‑Size child restraint system is engaged correctly in both mounting brackets in the vehicle.
or . or .