There are no persons in the vehicle.
The vehicle has been prepared for a wheel change More.
Use only a vehicle-specific jack that has been approved by Mercedes-Benz to raise the vehicle.
The jack is only designed for raising and holding the vehicle for a short time while a wheel is being changed and not for maintenance work under the vehicle.
The jack must be placed on a firm, flat and non-slip surface. If necessary, use a large, flat, load-bearing, non-slip underlay.
The foot of the jack must be positioned vertically under the jack support point.
Never place your hands or feet under the vehicle.
Never lie under the vehicle.
Do not start the drive system and do not release the electric parking brake.
Do not open or close any doors or the tailgate.
Before positioning the jack, you must remove the covers for the jack support points.
Make sure that the floor bush in the vehicle is correctly aligned to the cover.
If you do not position the jack correctly at the appropriate jacking point of the vehicle, the jack could tip with the vehicle raised.
You can damage the vehicle and, in particular the high-voltage battery, if you use a jack that is not specifically designed for the jack support points of the vehicle.
If you do not position the jack at the designated jack support points, you could damage your vehicle and, in particular, the high-voltage battery.