Mercedes-Benz

Moving the seat/bunk combination

You can move the seat/bunk combination only when it is unoccupied. Pull the seat/bunk combination forwards using only the loop between the sitting surface and the seat backrest.

If the seat sliders on the front rear seat row are too far back in the guide rails, the seat/bunk combination cannot be moved forward. In this case, use the handle for the seat sliders to move the seat sliders.

Pull release handle

up as far as it will go and hold it in this position.

Grasp the loop between the sitting surface and the seat backrest and move the seat/bunk combination.

Let go of release handle

.

The locking mechanism will engage automatically.

Make sure that all sliders for fore-and-aft adjustment engage audibly on both sides.

It should no longer be possible to move the seat/bunk combination.

Bed extension

To fold up:

pull release handle

back and move bed extension

into an upright position.

The bed extension will engage in an upright position.

To remove:

fold up bed extension

and unscrew thumbscrews

.

The bed extension will now be loose and capable of being removed from the guide rails.

To install:

guide bed extension

into the guide rails and tighten thumbscrews

.

Setting up/folding away the berth

WARNING Risk of injury or death if the berth is used while the vehicle is in motion

Any vehicle occupant using a bed while the vehicle is in motion cannot be restrained properly.

Use the bed only when the vehicle is parked.

WARNING Risk of becoming trapped when the seat backrest is folded up and down

When folding the seat backrest up or down, you could cause yourself or other vehicle occupants to become trapped.

Make sure that the range of movement of the seat backrest is clear and that no one is trapped.

The berth can accommodate two persons.

Fold up the short section of bed extension

.

Move the seat/bunk combination forwards to mark

on the guide rail.

Remove the head restraints of the seat/bunk combination.

Rotate the head restraints by 180° and insert them into brackets

on the rear side of the seat backrest.

Pull backrest release handle

up and adjust the seat backrest to a horizontal position. When doing so, hold on to the seat backrest only by the retainer loop.

Fold down the short section of bed extension

.

To fold away:

perform the steps to set up the berth in reverse order.

After use, finish by moving the seat/bunk combination back to the basic setting and ensure that the seat backrest is in an upright position.

Moving the seat sliders

When you remove the seat/bunk combination, a rear bench seat or a seat, the seat slider may slide in a guide rail. The seat sliders will then no longer be parallel in the guide rails. In this case, you can no longer fit the respective seating. The seat sliders must be moved only using handle for seat sliders or at a qualified specialist workshop in order to prevent the risk of damage.

In addition, you can use the end of the handle to open and close the locks on the sliders.

Handle is in the stowage compartment of the seat/bunk combination.

When you remove the seat/bunk combination, a rear bench seat or a seat, the seat slider may slide in a guide rail. The seat sliders will then no longer be parallel in the guide rails. In this case, you can no longer fit the respective seating. The seat sliders must be moved only using handle for seat sliders or at a qualified specialist workshop in order to prevent the risk of damage.

In addition, you can use the end of the handle to open and close the locks on the sliders.

The handle is in the stowage compartment of the seat/bunk combination More.

Place the tip of handle

onto the middle bolt of three bolts

.

Swing handle

downwards onto seat slider

.

Press seat slider

into guide rail

with handle

.

Seat slider will be unlocked.

Move seat slider

into the correct position and engage.